Can you run a screwdriver? If the answer is yes, you can install your coat rack. All tool boxes have the necessary tools already in it to mount a coat rack. To get started one needs to decide where you have a call for a coat rack, customarily located by an exit door. When the special part fastener position is has been resolved you will wish to resolve the elevation starting from the floor to put up your coat hooks. Common mounting heights are more or less around 40 inches for children to utilize and more or less around 62 inches for adult use. The finished elevation is up to you depending on your requirements. Find the around the center of your chosen spot of your coat rack and measure from the floor, if you are troubled about marking on the wall or are uncertain of the spot position a spot of removable tape on the wall and mark on the masking tape. This precludes marking directly on the wall. Using your level, again you can use a laser level situate the level or laser on your mark and hold it horizontal and mark the left and right ends of the spot of the coat rack. If a laser level or laser is not accessible you can obtain a piece of removable tape just about the length of the coat hook and position it on the wall level, stand back a short distance and thoroughly look at the removable tape does it look horizontal? if not adjust until you have a nice horizontal removable tape line. Once you get a nice parallel removable tape line to show you in the installing of your coat rack.